I failed to do this and a couple of the magnets managed to jump between the pieces before the glue had cured. Make sure after you've glued the magnet in place don't put the pieces too close. At this point I also tried to move some glue to cover the top of the magnet. Use a non-metal stick to move the magnet around to make sure it's centred in the hole. Keeping the angle of the stick low, quickly pull the stick away leaving the magnet in the glue. Maintaining the polarization of the magnet, stick it to the metal stick. Slide a magnet off the bottom of the stack. Use a match to pick up a spot of epoxy and deposit it in the routed hole. Firstly I aligned all the magnets so they were all north to south, this meant I was able to take one off the bottom of the stack and know it was correctly orientated. This took more than a bit of practice but check out the video for the final process.
With all 864 routing passes done it was now time for the glue up.
0 kommentar(er)
